The microporous aerator operates in the secondary treatment process at the sewage treatment plant. The aerator stimulates the sludge process by pumping air into the tank, thereby increasing microbial growth in the wastewater. These microbes begin to eat the organic food, forming sheep that settle easily. When they settle in a separate sedimentation tank, these fine bacteria disperse back to the blasting tank to improve the solution rate and micropore exposure. Gas can be divided into tube aerator, disc aerator, lifting aerator and aeration hose, rotary mixing aerator, corundum aerator and other different types, share with you how to install buckle aerator. The structure of clamp aerator (snap aerator). The common tubular aerator is a threaded connection of the saddle seat, and the aerator duct and fittings are completed by the manufacturer according to the drawings. After sent to the construction site, the construction personnel splice. Can be connected, save site construction time. Buckle aeration pipe and saddle seat are the same, are through the cloth pipe, the manufacturer will make in advance, different. Connect with a saddle seat, which sticks to the pipe ahead of time. Moreover, the clamp is connected, and the clamp wire buckle is screwed at the end of the aerator pipe. It is necessary to drill holes at the site and then connect the buckle.
The installation method of clip type aerator. After the air branch is installed and connected, the aeration pipe is installed on the air branch. At this time, two holes should be opened on both sides of the air branch, with an aperture of 15-20 mm. The opening must be on the same axis, and then the clamp is connected. Air branch connections should be kept horizontal to avoid unbalanced installation. Uneven ventilation.
